• Image of Second and third gen traction bar kit brackets only
  • Image of Second and third gen traction bar kit brackets only
  • Image of Second and third gen traction bar kit brackets only
  • Image of Second and third gen traction bar kit brackets only
  • Image of Second and third gen traction bar kit brackets only

Cnc plasma cut from .250" mild steel. Bar geometry is designed for pulling or drag racing. 60" bar minim length, the chassis brackets are designed to clear the body mounts when running the shorter bar. These can be bolted on or welded onto the frame. The rear brackets replace the factory lower I bolt clamp with a new clamp that integrates the rear traction bar mounts. These can be ordered in welded or welded. Please email me for the welded version and cost. The non welded kit will not come with the holes drilled, so you can drill them to the size you need for your joint. The center hole is .5" and can be bumped up from there. These fit a 1.250" hiem joint or a max width of 2.625 wide joint. I normally use rough stuff specialties or ballistic fab depending on the application.

If ordering for a third gen please email me your rear axle u bolt spacing so I can get you the correct base flange.